The Front Bumper Bracket Hardware Kit is an OE-style fastener set designed for 1966–1967 Chevrolet Chevy II and Nova models. This 12-piece kit provides the correct hardware needed to secure the front bumper brackets to the vehicle, restoring proper bumper mounting and factory-style alignment. It is an essential component for classic muscle car restoration parts projects where correct fit, appearance, and fastener detail matter.
During restoration or collision repair, original bumper hardware is often missing, corroded, mismatched, or replaced with incorrect fasteners. Using improper hardware can affect bumper alignment and detract from an otherwise accurate restoration. This kit addresses that issue by supplying OE-style hardware designed to match the size, thread, and appearance of the original factory fasteners used on 1966–1967 Chevy II and Nova front bumper brackets.
Manufactured as an OE-style reproduction, this hardware kit is intended for use with original-style bumper brackets and factory mounting locations. The fasteners are designed to support correct bumper positioning relative to the front valance, grille, and fenders, helping maintain proper front-end alignment and spacing.
This kit includes 12 pieces, providing coverage for the front bumper bracket mounting points required on applicable models. It is well-suited for restorers completing a full front-end rebuild, bumper replacement, or detail-correct restoration where original-style hardware is expected.
Offered as X-Parts by Auto Metal Direct, this hardware kit is a third-party OE-style replacement selected to meet AMD’s standards for fit and application accuracy. X-Parts provide dependable solutions when AMD all-new tooling components are not required, while still supporting factory-correct restorations.
Auto Metal Direct is a team of true car guys with years of experience in sheet metal reproduction, car restoration and paint/body work. We believe that quality is not subjective! Our mission is to provide the best customer experience for the Ford, Mopar and GM classic car markets - both in products and in service.
Our panels are made from proper gauge steel and include all correct-as-original clips, tabs, flanges, bends and seams. Each time a prototype body panel comes off of a new tooling, we test fit it on a car. The marked up prototype is then used to change and improve the tools, and a new prototype is produced. This procedure might be repeated multiple times but, once the part is finally approved, you can be assured of a quality part.
| Make | Model | Years |
| Chevrolet | Chevy II | 1966 - 1967 |
| Brand | X-Parts |
